Hi, everyone! Just wanted to share more samples with you from the February release by Divinity Designs LLC. To see all of the new goodies and some amazing designer samples, visit the online store HERE or check out the Instagram link HERE.
If you have any questions about products or techniques used in these cards, please provide your email address in the comments and I will get back with you.
Thanks so much for stopping by!
Blessings,
Hi, everyone! It's time for the next release in the Special Occasion of the Month series by Divinity Designs LLC. If you'd like to save a little money, check out the subscription details HERE! This month's occasion set is St. Patrick's Day.....the girls have made some awesome, creative samples....check them out HERE on the website or HERE on Instagram! Kelley also released a fun new paper pad to coordinate with this set! Enjoy!
.jpg)
My first sample features my favorite designer paper pattern from the Shamrock Greenery A2 Card Fronts, along with the St. Patrick's Day clear stamps and the following dies: Quilted Background, Matting Rectangle, A2 Portrait Card Base with Layer, Double Stitched Circles, Circles, Clouds and Raindrops, Pine Branches. I used four tiny hearts from the Clouds and Raindrops Dies and a snip from the Pine Branches Die to create each die-cut shamrock.
My next sample was a bit challenging but fun. The sentiment was stamped onto the designer paper from the Shamrock Greenery A2 Card Fronts, die cut with the Slatted and Eclipse - Square Dies. Here are the steps in order for assembling the pieces: 1. Cut and emboss the designer paper panel with a Pierced Rectangles Die. 2. Stamp the sentiment. 3. Cut with the Slatted and Eclipse Square Dies. 4. Adhere the full panel (minus the square cut-out) to the ivory mat. 5. Apply thin strips of Scor-Tape onto the cut-outs while the paper is still inside the die. 6. Carefully peel off the outer layer of the Scor-Tape so that the strips stay in the die. 7. Line up the entire square back into the designer paper. 8. Press the strips to the ivory mat. 9. Lift the dies and remove the top frame. 10. Add Foam Mounting Tape to the top designer paper frame. 11. Carefully line up the frame over the strips and adhere. Whew! When using designer paper only with the new slatted dies, I use the same method, but you don't have to be quite so picky matching up the design! To finish the card, black baker's twine was added, along with hearts cut with the Layering Hearts Dies.
Thanks for hanging out with me today!
Blessings,
Hi, everyone! January flew by and now it's time for another New Release from Divinity Designs LLC! Please check out all of the new goodies plus lots of awesome project photos HERE on the website or HERE on Instagram. Enjoy!
My first project features the following products:
(There are multiple photos so that all of the angles could be seen.)
My next card features one of the awesome patterns from the Watercolor Forest A2 Card Fronts pack, the new Tree Border Die, and the Slatted & Eclipse - Rectangle Die set, and the Happy Birthday with Layers Dies. My trick to lining up the pieces of the slatted dies is to leave the designer paper in the die after cutting, add double sided tape to the strips, line up the die with the mat layer, then press the strips to the mat layer. Lift up the die and remove the die cut frame; add foam tape; line up pattern and adhere to the lower panel. Additional products used: Pierced Rectangles, Matting Rectangle, A2 Landscape Card Base with Layer, Blending Brushes, and Foam Mounting Tape.
Blessings,
Hi, everyone! Please forgive the lack of posts of late. Life has been a bit busy!
Below are the additional samples created with the products from the January New Release from Divinity Designs LLC. If you have any questions, please leave a comment with your email address and I will get back with you.
Thanks for visiting!
Blessings,
